aha. also dann kann ich das airport-programm vergessen.
also ich kann mit kismac die wlan karte meines routers sehen, aber wie mache ich dem mac begreiflich, dass er per ad-hoc verbindung damit aufnehmen soll??
hier mal die configs des routers...
OPT_WLAN='yes' # Install Wireless extensions
WLAN_N='1' # Number of independent WLAN-Configurations
WLAN_1_MAC='00:60:1D:1E:29:2D' # MAC-Address of WLAN-Card to bind this config on
WLAN_1_ESSID='fli4l' # ESSID - Network Name
WLAN_1_MODE='ad-hoc' # WLAN Modus - ad-hoc without Access-Point
WLAN_1_CHANNEL='1' # WLAN-Channel 1-13 in Europe allowed
# 0 for WLAN_%_MODE='managed' = Auto-Scan
# Append a, b or g to select Operating Mode if needed
WLAN_1_RATE='2' # WLAN-Bitrate (1,2,5.5,11,auto) in Megabit
WLAN_1_ENC_N='0' # Number of configured WEP-Keys (0-4)
WLAN_1_ENC_1='' # 1st WEP - Encryption key
WLAN_1_ENC_2='' # 2nd WEP - Encryption key
WLAN_1_ENC_3='' # 3rd WEP - Encryption key
WLAN_1_ENC_4='' # 4th WEP - Encryption key
WLAN_1_ENC_ACTIVE='1' # Active sending WEP Key index
WLAN_1_WEP_ROTATE='0' # Rotate the active WEP-Key every n seconds
WLAN_1_WPA_KEY_MGMT='' # key management policy, currently
# only WPA-PSK available
WLAN_1_WPA_PSK='' # pre shared key
WLAN_1_WDS_N='0' # How many WDS-Links should be established?
WLAN_1_WDS_1_MAC='00:60:1D:1E:29:2D' #00:02:6F:01:71:3E' # MAC Adress of th AP
WLAN_1_WDS_1_BRIDGE='fli4l' # Bind to Bridge with symbolic name
WLAN_1_WDS_1_BRIDGEPRIO='128' # Port-Priority on Bridge (see Bridge-Documentation)
WLAN_1_WDS_1_BRIDGECOST='100' # Traffic-Cost on Bridge (see Bridge-Documentation)
WLAN_1_WDS_MODE='1' # WDS-Standard? Default: '4' (requires Prism-II-Firmware >=1.5.6) otherwise use '1'
WLAN_1_ACL_POLICY='open' # Possible values: open, allow, deny
WLAN_1_ACL_MAC_N='0' # Number of MACs
WLAN_1_ACL_MAC_1='00:02:2d:44:b5:ca' # First MAC
ich danke schon mal für vorschläge und wünsche einen ruhigen abend