PM G3 Netzteil ein Standart ATX Netzteil?

CooperRS

Aktives Mitglied
Thread Starter
Dabei seit
05.03.2005
Beiträge
367
Reaktionspunkte
10
Hallo,
Ich wollte mal fragen, ob das Netzteil im PM G3 B&W ein Standart ATX Netzteil ist? Wenn ja kann ich das dann durcfh ein aderes ersetzten, bei dem der Lüfter im Ruhezustand ausgeht?
Hintergrund:
Hab jetzt schon den 120mm Lüfter abgestöpselt und wenn ich dann noch das Netzteil wechseln könnte, würde mein Mac endlich keinen Ton mehr im Ruhezustand von sich geben...
 
Hallo,

ich habe in meinen G3 BW ein ATX Netzteil eingebaut, jedoch muß der Stecker geändert werden:


ATX Power

The B&W G3 uses a power supply that's almost but not quite identical to an ATX supply. The lone difference is that the wire which supplies -5V on an ATX supply (pin 18) becomes a ground wire in the B&W G3.If you just plug in an ATX supply without any modifications, you'll short out its -5V output.

One way of dealing with this is to simply remove the original ATX supply from the PC case and substitute the supply from the B&W G3. However, this means that you can't take advantage of the 300W or bigger ATX supplies, one of the reasons to do an ATX conversion in the first place.

The other solution is to snip or remove the -5V wire from the ATX connector. Actually, I found an ATX power extender cable at a PC store, and snipped the -5V wire on that instead, to avoid permanently altering the power supply's own wiring. You'll likely need an extender cable anyway. [Note: PC Power and Cooling sells a 12" ATX PS Extender cable on their Accessories page-Mike]
The G3 motherboard's power connector is all the way at the bottom of the case, and few PC ATX supplies have a power cable long enough to reach. Here are pictures of the female and male ends of the extender with the -5V wire snipped out.
( http://www.xlr8yourmac.com/systems/MacinPC_ATX_case/Blue_G3_to_ATX.html )

Denk aber an den Luftstrom der die CPU kühlt, ansonsten wird dein Mac bald garkeinen Mucks mehr von sich geben!

mfg
Gregor
 
Zurück
Oben Unten